©2007 PLAYNATION PLAYSYSTEMS INC.
STEP 9: BAMBOO PANELS
1: FIND ONE 62" BAMBOO PANEL, ONE 39" BAMBOO PANEL, ONE 10" BAMBOO PANEL, AND TWO 6" BAMBOO
PANELS. THE PANELS WILL BE HOLLOW ON ONE END. THIS END WILL BE THE BOTTOM. NOTE THE PRE-DRILLED HOLES
ON THE PANELS; THESE WILL BE USED TO FASTEN THE PANELS TO THE UNIT.
2: FASTEN THE 62" BAMBOO PANEL TO THE REAR BOTTOM AND REAR TOP PANEL BOARDS WITH 2-1/2" WOOD
SCREWS. DO NOT OVER TIGHTEN AS THIS WILL CAUSE THE BAMBOO TO SPLIT.
3: FASTEN THE 39" BAMBOO PANEL TO THE SWING BEAM SUPPORT AND BOTTOM PANEL BOARDS WITH 2-1/2" WOOD
SCREWS.
4: FASTEN THE 10" BAMBOO PANEL TO THE CENTER OF THE FRONT FACE BOARD AND TOP PANEL BOARD WITH 2-1/2"
WOOD SCREWS.
5: FASTEN THE TWO 6" PANELS TO THE LEFT AND RIGHT SIDE OF THE FRONT FACE BOARD AND TOP PANEL BOARD
WITH 2-1/2" WOOD SCREWS.
NOTE: BECAUSE THE BAMBOO USED IN THE BAMBOO PANELS MAY BE DIFFERENT SIZES, IT MAY BE NECESSARY TO USE
A 2" WOOD SCREW TO PREVENT THE SCREWS FROM COMING OUT OF THE BOARDS ON THE OPPOSITE SIDES. BEFORE
PLACING EACH SCREW; MAKE SURE THAT THE WOOD SCREWS WILL NOT GO THROUGH.
10" BAMBOO PANEL
39" BAMBOO PANEL
62" BAMBOO PANEL
6" BAMBOO PANEL
