IF ENDS
GABLE
ROOF
ASSEMBLY
ROOF FINISHER
ARE FLUSH
FRONT RIGHT
1 X 4 X 29.29"
1 X 4 X 29.29"
FRONT LEFT
ROOF FINISHER
IDEAL
ROOF BOARD
#8 X 1-1/2"
WOOD
SCREWS
(3 PER SIDE)
A
IF THE FINISHER
DRILL NEW HOLES
BESIDE THEM.
SUPPORT THEN
SCALE 1 : 4
DETAIL A
THEN TRIM IT.
OVERHANGS
IF THESE HOLES
ARE NOT CENTERED
OVER THE ROOF
NEW HOLES
STEP 20: ROOF FINISHERS FRONT
1: PLACE THE RIGHT ROOF FINISHER INTO THE GROOVE OF THE ROOF BOARD.
2: SLIDE THE FINISHER OVER UNTIL IT HITS THE GABLE ASSEMBLY ROOF. IF THE FINISHER STICKS OUT BEYOND THE END
OF THE ROOF BOARD ABOVE IT THEN YOU WILL HAVE TO TRIM IT. MARK THE END OF THE FINISHER AND CUT IT TO
LENGTH.
(IF THE FINISHER IS FLUSH TO THE END OF THE ROOF BOARD ABOVE IT THEN ALL YOU NEED TO DO IS TO ATTACH IT
WITH THREE #8 X 1-1/2" WOOD SCREWS)
3: RESTAIN THE TRIMMED END OF THE FINISHER IF YOU CUT IT WITH THE STAIN PROVIDED.
4: AT THIS POINT YOU MAY NOTICE THAT THE TWO SMALL HOLES MAY NOT BE CENTERED OVER THE ROOF
SUPPORT. IF THAT IS THE CASE THEN DRILL TWO SMALL HOLES THAT ARE CENTERED OVER THE ROOF SUPPORT AND
INSTALL TWO #8 X 1-1/2" WOOD SCREWS.
REPEAT SUBSTEPS 1 THROUGH 4 FOR THE LEFT ROOF FINISHER
48
