4: MAKE THE WALL PANEL SUPPORT PARALLEL TO THE ROOF BOARD. INSTALL A 5/16" X 3-1/2" LAG SCREW WITH 5/16" WASHER
IN THE COUNTERBORED HOLE.
5: REPEAT SUBSTEPS 1 THROUGH 4 FOR THE RIGHT WALL PANEL SUPPORT.
PANEL BOARD WITH THE MARK. USE THE HOLE IN THE WALL PANEL BOARD TO DRILL A 1/8" PILOT HOLE THROUGH THE SHORT
SUPPORT UNDER IT. THE TOP OF THE FINISHER NEEDS TO BE FLUSH TO THE TOP OF THE ROOF BOARD ABOVE IT.
3: ALIGN THE BACK OF THE WALL PANEL SUPPORT FLUSH TO THE BACK OF THE GABLE ASSEMBLY. ALIGN THE TIP OF THE WALL
STEP 19: WALL PANEL SUPPORTS
ROOF BOARD IN THE GABLE ASSEMBLY. INSTALL A 2-1/2" WOOD SCREW IN THE HOLE.
2: SLIDE THE FINISHER OUT AND THEN MAKE A MARK AT THE END OF THE TIP OF THE WALL PANEL BOARD.
SINCE ALL INSTALLATIONS VARY THE 15-13/16" DIMENSION SHOWN MAY NOT BE CORRECT. FOLLOW THE PROCEDURE BELOW
TO POSITION THE WALL PANEL BOARDS PROPERLY.
1: SLIDE THE LEFT ROOF FINISHER (NOT SHOWN) AGAINST THE ROOF BOARD TEMPORARILY. THEN PUSH THE WALL PANEL
WALL PANEL SUPPORT LEFT
LEFT ROOF FINISHER (NOT SHOWN)
INSTALL 5/16" X 3-1/2" LAG SCREW WITH 5/16" WASHER IN THE COUNTERBORED HOLE.
2 X 4 X 22-3/4"
WALL PANEL SUPPORT RIGHT
HERE AT THE TIP.
GABLE ASSEMBLY
2 X 4 X 22-3/4"
2-1/2" WOOD SCREW
MAKE A MARK
ROOF
BOARD
15 13/16"
47
