• Screw on the relevant fixed grill for a low level
suction or directional eyeball for a return inlet.
• Using the PTFE tape supplied, insert a hosetail
fitting to the rear of the low level suction / return
(and skimmer if supplied).
• You can now connect the standard cartridge filter
supplied with your pool.
• If you have upgraded to a sand filter, please refer
to the upgrade instructions at the back of this
manual (page 17).
• Skimmer and return fitting as on 10ft pool below.
x2 for 8ft pool
10ft pool
• Continue to fill the pool until the water level is
approximately 50mm from bottom of the skimmer.
• Using the same method as for the low level suction
/ return, locate your screws in the four corners of
the skimmer. Carefully cut the crosshairs of the
screws, remembering North, South, East and West
positions. Ease the screws through a small incision
in the liner.
• Using the screw positions in the four corners will
help you align the faceplate for the skimmer. Do not
forget to stick the gasket supplied on the rear of the
faceplate.
• When you have tightened the four screws in the
corners, continue fixing the rest of the screws using
a handheld screwdriver (not cordless).
10ft pool
– 15 –