• Find the 4 bottom half planks that have a flat under
side and two tongues facing upwards. Place these
flat side down as shown below.
• Using 4 standard planks you can now form the first
layer of the pool walls. The 45 degree interlocking
slot at each plank end will form the shape of your
pool.
• Fit the next layer of planks so each side has two
layers.
• Continue to fit layers of planks.
• Choose the position for your filtration wall carefully.
•
8ft Models Only:
There is no skimmer plank. You
will be provided with an inlet and low level suction
plank which has two holes. Install this on the 3rd
full plank from the bottom.
•
10ft Models Only:
Install the inlet plank as the third
full plank up (on 3ft depth pools this should be the
second full plank above the bottom half plank).
• The flower shaped cutout should be on the inside
of the pool.
• Continue to build up the walls checking alignment.
• Using all the standard planks, firmly tapping them
into place and checking for level as you go.
•
10ft models only:
For 4ft depth pools, insert the
lower skimmer plank on the 8th layer (same wall as
the inlet).
•
10ft models only:
For 3ft depth pools, the lower
skimmer plank should be on the 5th full plank up on
the wall which starts with a bottom half plank (same
wall as the inlet).
– 7 –