Installing the Liner
• Once you have approximately three inches of water
in the pool, get into the pool bare foot and work out
any remaining creases in the pool floor by pushing
them with your foot from the middle of the pool to
the outside.
• Continue to fill the pool until you are an inch below
the inlet/low level suction fittings.
• You may have noticed that the liner seemed too
small to begin with, but with the pressure of the
water it will stretch into place.
• At this stage you may wish to install your linerlock
wedge. Start in one corner and work your way
around the perimeter using reasonable pressure to
push it in using your thumbs.
• Prior to fitting your liner, ensure the following: The
liner has been stored in a warm environment and
that you have carefully examined and removed any
sharp objects from inside the pool area. When
installing the liner wear socks to protect the liner
from any damage caused by footwear.
• Start to position the liner at a bottom corner of the
pool. Make sure each corner floor weld of the liner
corresponds with the corners of the pool.
• Work your way around the pool inserting the
beaded edge of the liner into the Linerlock.
• Use your feet to move any creases in the liner from
the middle of the floor to the outside edges.
• When you have done this you can begin to fill the
pool with water.
– 13 –
