ADW-4302v2 User Guide
Macintosh Clients
From your Macintosh, you can access the Internet via the ADW-4302v2. The proce-
dure is as follows.
1. Open the TCP/IP Control Panel.
2. Select
Ethernet
from the
Connect via
pop-up menu.
3. Select
Using DHCP Server
from the
Configure
pop-up menu. The DHCP Client ID
field can be left blank.
4. Close the TCP/IP panel, saving your settings.
Note:
If using manually assigned IP addresses instead of DHCP, the required changes are:
•
Set
the
Router Address
field to the ADW-4302v2's IP Address.
•
Ensure your DNS settings are correct.
Linux Clients
To access the Internet via the ADW-4302v2, it is only necessary to set the ADW-
4302v2 as the "Gateway".
Ensure you are logged in as "root" before attempting any changes.
Fixed IP Address
By default, most Unix installations use a fixed IP Address. If you wish to continue
using a fixed IP Address, make the following changes to your configuration.
•
Set your "Default Gateway" to the IP Address of the ADW-4302v2.
•
Ensure your DNS (Name server) settings are correct.
To act as a DHCP Client (recommended)
The procedure below may vary according to your version of Linux and X -windows
shell.
1. Start your X Windows client.
2. Select
Control Panel - Network
3. Select the "Interface" entry for your Network card. Normally, this will be called
"eth0".
4. Click
the
Edit
button, set the "protocol" to "DHCP", and save this data.
5. To apply your changes
•
Use the "Deactivate" and "Activate" buttons, if available.
•
OR, restart your system.
Other Unix Systems
To access the Internet via the ADW-4302v2:
•
Ensure the "Gateway" field for your network card is set to the IP Address of the
ADW-4302v2.
•
Ensure your DNS (Name Server) settings are correct.
36
