6
Assembly
Tip! If possible, use a forklift truck to lift the oven to fit
the legs. Alternatively, lift the oven manually on to a
strong table or flat bench, so that the legs can be fitted
safely.
Minimum lift height for fitting of legs:
1-deck oven
1105 mm
2-deck oven
935 mm
3-deck oven
765 mm
Approximate weights:
1-deck oven
200 kg
2-deck oven
350 kg
3-deck oven
500 kg
Important!
Do not remove the wooden supports for the
hearthstones until you reach point 7 opposite.
Do not use the oven-door handles or the oven-
vent knobs to lift the oven, for it can damage the
oven.
Assembly
Important! Fit the 2 legs with the lockable wheels to
the front of the oven, and the 2 legs with non-lockable
wheels to the rear.
1. Lift the oven and fit the legs using the M10x30 bolts
(12 pcs) + 20x10.5 washers (12 pcs) provided.
For each leg, first screw in (but do not tighten) the
internal bolt, i.e. the one that has to be inserted
through the top inside of the leg. Then screw in the
2 external bolts, but do not tighten. Now tighten the
3 bolts progressively and alternately to fix the leg
firmly to the oven.
2. Fit the slide rails (4 pcs) to the legs as shown below,
using the self-tapping screws provided (16 pcs).
3. Insert the sliding shelf into either the upper or the
lower pair of rails, as required. (1 sliding shelf is
supplied as standard)
4. Fit the steam duct, using the screws provided (4
pcs).
5. Fit the flue diverter, using the self-tapping screws
provided (4 pcs).
Important! Make sure the open long-side faces
forward.
6. Fit the exhaust outlets (2 pcs).
7. Remove the wooden supports that hold the hearth-
stones in place.
8. Remove all protective plastic film from the oven.
4
5
6
1
2
3
