14
1. Operation
029> OMREX
Paper/ DF OMR
<PROG
030> EXAMPLEJOB
Paper/ DF BCR
1. Check loading Orientation
GREEN=CONFIRM
BLUE=EXIT
Program selection
To select a program, scroll until it appears on the first line of the display as indicated by the
arrow <PROG prompt. Press GREEN to select the program.
You are asked about running pre-run adjustments. If this is a new job, press Green and
carry out the adjustments as described. If pre-run adjustments have already been carried
out or if this is a current job, press Red. If you skip the pre run adjustment you go straight
to Start the Job below.
Loading orientation
The four possible loading orientations are shown upon program selection:
The first check asks you to make sure the material orientation is correct.
The four possible loading orientations are:
1.
Face up, bottom first
2.
Face up, top first
3.
Face down, bottom first
4.
Face down, top first
When feeding individual pieces of material during setup or when loading material prior to a
job run, it is important to observe the correct loading orientation for the program selected.
Press GREEN to go to the next step.
Summary of Contents for F65A
