Pitney Bowes F65A, Operator'S Manual

Page: 32 / 50

32
2. Main menu
Modify job
The actual selected job will automatically be selected in the modify job menu. You can
scroll through the programmed jobs until the job to be modified has been found by using
the two arrow buttons for selection. Jobs may be identified by their number or name (far
left/far right on top line, see diagram below).
001> Name of program : EXAMPLEJOB
<>=SELECT Green=CONF. Blue=EXIT Red=EDIT
After a job to be modified has been selected, all steps of programming are run through.
Push through all parameters you wish to remain unchanged by confirming (pressing
GREEN). The changes take place immediately and there is no second confirmation re -
quired. To modify a job parameter either scroll through the given choices using the arrow
buttons (<>) some settings can be altered by pressing RED to edit an entry. Press BLUE
to exit at any time.
Delete job
Scroll through the programmed jobs until the job to be deleted has been found. The job
selected on the home screen will automatically be selected in the delete job menu. Jobs
may be identified by their number or name (far left/far right on top line, see diagram be -
low).
001> Name of program : EXAMPLEJOB
<>=SELECT Green=DELETE Blue=EXIT
Are you sure?
Green=YES Blue=EXIT Red=NO
After pressing GREEN for deletion a confirmation is needed to delete the job in question.
EXIT and NO have the same effect leaving the whole menu without a change