32
EN
ENGLISH
DISCONNECTING A GAS CYLINDER
1. Ensure the regulator valve on the grill is completely closed by turning the knob clockwise to the OFF position.
2. Turn the cylinder counter-clockwise (by hand) to disconnect from the regulator valve opening. Replace the protective
caps on the regulator valve opening and the top of the gas cylinder for storage (if not empty).
NOTE: If storing the grill indoors, leave the gas cylinder outdoors.
WARNING: Do not fold up or transport grill with gas cylinder attached. The cylinder may loosen off the
valve and cause a gas leak, possibly resulting in an explosion, fire, or severe bodily harm. Disconnect gas
cylinder first before travel or storage.
Never
light your gas grill with the lid closed or before checking to ensure the burner tubes are fully seated over the gas valve orifices.
Electrical equipment provided with the outdoor cooking gas appliance shall have the following in the instructions:
a. To protect against electric shock, do not immerse cord or plugs in water or other liquid;
b. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts;
c. Do not operate any outdoor cooking gas appliance with a damaged cord, plug, or after the appliance malfunctions or has been
damaged in any matter. Contact the manufacturer to repair;
d. Do not let the cord hang over the edge of a table or touch hot surfaces;
e. Do not use an outdoor cooking gas appliance for purposed other than intended;
f. When connecting, first connect plug to the outdoor cooking gas appliance then plug appliance into the outlet;
g. Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance;
h. Never remove the grounding plug or use with an adaptoer of 2 prongs;
i. Use only extension cords with 3-prong grounding plug, rated for the power of the equipment, and approved for outdoor use
with a W-A marking.
The outdoor grill, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes with
the National Electrical Code ANSI/NFPA 70, or Canadian Electrical Code, CSA C22.1.
1. Do not store a spare LP gas tank under or near this appliance.
2. Never fill the tank beyond 80 percent full.
3. If the information in 1) and 2) is not followed exactly a fire causing death or serious injury may occur.
4. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder
valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane.
UNDERSTANDING THE CONTROL KNOBS
GAS BURNER KNOB
OFF
LIGHT
LOW
OFF
ELECTRIC SMOKER KNOB
