DISASSEMBLY
10
The Piranha
®
is easy to strip for cleaning and basic maintenance.
Regular cleaning and maintenance
is highly recommended.
Keep screws tightened. Replace worn components with factory parts; all leaks must
be repaired promptly. Air system repairs are best performed by the factory or an authorized factory repair facility.
Contact KEE for information regarding authorized Piranha
®
repair facilities.
DISASSEMBLY PROCEDURE
1. Before disassembling the marker, first remove the air tank, and then remove all paintballs from
the marker, barrel, and loader.
Figure 8. Remove field strip pin to
begin disassembly.
W
WA
A R
R N
N II N
N G
G
DO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED TO DO SO. DO
NOT DISASSEMBLE MARKER UNTIL IT IS COMPLETELY DRAINED OF COMPRESSED GAS OR AIR AND
ALL PAINTBALLS HAVE BEEN REMOVED. ALL FILLING OF COMPRESSED GAS OR AIR CYLINDERS MUST
BE DONE BY QUALIFIED PERSONS.
CONTACT KEE FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED PIRANHA
®
REPAIR FACILITIES. PHONE 800.724.6822; KEEACTIONSPORTS.COM
THE PAINTBALL MARKER AIR SYSTEM MUST BE REPAIRED OR REPLACED ONLY WITH THE CORRECT
PRESSURE RATED COMPONENTS.
2. Leave barrel plug firmly inserted in barrel and keep barrel
pointed in a safe direction.
3. To remove the bolt/hammer assembly, first remove the field
strip pin. See Figure 8. The field strip pin is at the center
rear of the receiver and is removed by pulling it out of the
left side of the marker.
4. Grasp the block assembly and slowly begin to pull the bolt/hammer assembly out of the marker. See Fig. 9.
5. When the bolt/hammer assembly is about halfway out, grasp it with one hand and continue to hold it
intact while removing it completely from the marker. See Figure 10.
Figure 11 - Bolt-hammer assem-
bly removed.
Figure 9
Figure 10 - Grasp assembly.
Oil Here
Oil Here
Manual_Piranha_6.0_eng_fr_sp.qxp 2/6/08 5:02 PM Page 11
