Manual for StealthTouch M5-M7 with Core Pentium & Core i-Series Model v1.0
Page 19
Pin 1
Pin 1 (Data carrier detect)
Pin 2
Pin 2 (Receive data)
Pin 3
Pin 3 (Transmit data)
Pin 4
Pin 4 (Data Terminal Ready)
Pin 5
Pin 5 (Signal ground)
Pin 6
Pin 6 (Data set ready)
Pin 7
Pin 7 (Request to send)
Pin 8
Pin 8 (Clear to send)
Pin 9
---
5.3
Power supplied by serial port/COM port
By default, COM Port 2 does not supply power. It can be set to 5V or +12V power by modifying jumper setting on
Jumper COM2_DCD and COM2_RI on the System Board. Please see table below for setting of these two jumpers. Power
will be available on Pin 1.
[Warning]
If COM Port 2 is set with power, users shall not plug in other devices to that port. Failure to do so may result in
damages on connected devices.
COM2_DCD: COM2 DCD Jump setting
Connector: HEADER 2X3P G/F 2.0MM BLK S/T
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
COM2_ RI: COM2 RI Jump setting
Connector: HEADER 2X4P S/T,2.0mm,DIP
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2
12V
3-4
5V
5-6
RI2#
7-8
GND
(default)
[Note]
Call PioneerPOS tech support at 909-468-9757 or email [email protected] for detail info on how to make
changes.
1-2
12V
3-4
5V
5-6
DCD
(default)
Pin 1
Pin 1
Pin 2
