#
When a subwoofer is connected to the rear
output, select
SUB. W
(subwoofer).
#
When the rear output setting is
SUB. W
, you
cannot change the subwoofer controller.
3
Touch
c
or
d
on the PREOUT setting to
switch the subwoofer output or non fading
output.
Touch
c
to select subwoofer output and
SUB.W
appears in the display. Touch
d
to se-
lect non fading output and
FULL
appears in
the display.
Notes
!
Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to
Using nonfading output
on page 82)
or subwoofer output (refer to
Using subwoofer
output
on page 82) in the audio menu on.
!
If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
!
The sound is turned off,
MUTE
is displayed
and no audio adjustments are possible.
!
The sound is attenuated,
ATT
is displayed
and no audio adjustments, except volume
control, are possible.
!
Sound from this system returns to normal
when the muting or attenuation is can-
celed.
%
Touch TEL/GUIDE on the initial menu to
select any of the muting, attenuation or
off.
Touch
TEL/GUIDE
until the desired setting ap-
pears in the display.
!
MUTE
–
Muting
!
ATT -20dB
–
Attenuation (
ATT -20dB
has a
stronger effect than
ATT -10dB
)
!
ATT -10dB
–
Attenuation
!
OFF
–
Turn the sound muting/attenuation
off
Notes
!
The sound is muted or attenuated,
MUTE
or
ATT
are displayed and no audio adjustment is
possible.
!
Operation returns to normal when the phone
connection or the voice guidance is ended.
Mixing AVG-VDP1 beep and
audio sound
When connecting the AVG-VDP1 to this unit, a
beep sound is occasionally outputted from the
AVG-VDP1. To ensure the quality audio sound
from this unit, set this function to
GUIDE
to
properly mix the beep sound and the audio
sound.
!
You can operate this function only when a
Pioneer Vehicle Dynamics Processor (AVG-
VDP1) is connected to this unit.
!
When the multi-channel processor (e.g.,
DEQ-P8000) is connected to this unit, you
cannot use this function.
!
We recommend that you select
GUIDE
to
ensure quality sound.
Initial Setup
En
104
Section
22
