Pioneer SGY-PM930H, User Manual

Page: 22 / 242

22
EN
G
et
tin
g S
ta
rte
d
Switch to dual power meter mode
By pushing the push switch in the right
transmitter for more than 3 seconds,
the LEDs on the right transmitter blink
green. When communication with
the left transmitter is enabled, the
LEDs on the left and right transmitters
rapidly blink orange.
Confirm that the LEDs on the left and
right transmitters blink when the mode
is switched. (If they do not blink, the
communication may have been done
with another pedaling monitor sensor
by mistake. Move somewhere away
from the other bicycles and do the
operation again.)
While the blinking takes place rapidly
for 10 seconds, push the switch
again during that time for more than
3 seconds. The mode is switched to
the dual power meter mode. When
the mode is switched, the LED starts
lighting orange for 10 seconds. If you
do not push long while the LEDs are
rapidly blinking orange , it is canceled
and so, you must do the operation
again.
• It may take several seconds to
switch the sensor mode depending
on the radio transmission conditions.
If the pairing with the left transmitter
fails, the LEDs of the right transmitter
blink red five times. Remove the
batteries from the left and right
transmitters, wait for more than one
minute. Place the batteries back and
do the operation again.
After the mode is switched, install the
right transmitter cover and tighten the
screws to fix it in place. Use a tool that
can measure the torque to tighten the
screws.
• Tightening torque: 30 cN·m
• Install the transmitter cover and
the screws in firmly to ensure water
resistant performance.
• Do not lose the water-proof packing.
For how to pair with the cyclocomputer,
when using SGX-CA600, refer to Page
25 and if using a cyclocomputer
from another manufacturer, refer to the
User's Manual of that cyclocomputer.