Pioneer SGY-PM930H, User Manual

Page: 15 / 242

15
EN
G
et
tin
g S
ta
rte
d
Installing and Removing the Batteries
4. Check the LED display.
The transmitter starts when the
batteries are installed. The LEDs
of the transmitters light as follows
depending on the actual sensor mode.
• When it is in pedaling monitor
mode:
The LEDs
light
green for 10
seconds
• When it is in dual power meter
mode:
The LEDs
light
orange for 10
seconds
• When it is in single power meter
mode:
The LEDs
blink
orange for 10
seconds
Push switch
LED
Water-proof
packing
• If the LEDs do not light for more
than 5 seconds after installing the
batteries, remove the batteries
once, and after more than 1 minute,
install them again. If the LEDs still
do not light, the battery may be
almost empty. Replace the battery
with a new one. Dispose of useless
batteries as instructed by the local
government.
5. Install the right transmitter
cover and tighten the screws
to fix it in place.
While tightening the screws, do not
use excessive force or over-tighten
them. The plastic cover can crack
if you do so. Use a tool that can
measure the torque to tighten the
screws.
• Tightening torque: 30 cN·m
• Install the transmitter cover and
screw the screws in firmly to ensure
water resistant performance.