Pioneer SGY-PM930H, User Manual

Page: 25 / 242

25
EN
Pai
ring
/C
al
ib
ra
tion
Pairing with the Cyclocomputer
This section describes how to pair the installed pedaling monitor sensors on
your bicycle to the SGX-CA600 Cyclocomputer.
● If you are using this product with a Cyclocomputer from another
manufacturer, the method of pairing is different. Refer to the User’s Manual
of the Cyclocomputer you are using.
1. Check the sensor modes.
The actual sensor mode can be
confirmed from the way the LEDs of
the sensors light when the batteries
are installed, or from the way the LEDs
light on switching to each mode.
• Refer to Page 16 to switch the
modes.
2. Select [Bike] - [Sensors]
in the main menu of SGX-
CA600.
The sensor list screen opens.
3. Rotate the bicycle’s crank
set more than three rotations
to start the transmitters.
• After the transmitters are activated, it
may take more than 1 minute to pair
with the Cyclocomputer.
• Pair with the Cyclocomputer within
5 minutes after the transmitters are
activated.
4. Select [Add Sensor] in the
sensor list screen of SGX-
CA600.
The list of peripheral sensors that can
be connected appears.
5. Select the checkboxes for
sensors to be added to the
sensor list.
• In pedaling monitor mode, the left
pedaling monitor or right pedaling
monitor appears.
• In single or dual power meter mode,
the ANT+ power meter appears.
• If multiple sensors are activated,
options for the multiple sensors
appear. Check the device number
and select the checkboxes for the
sensors to be connected.