If your surface is not between 2.5 and 4.5cm thick or you can’t access the other side surface, you need a
LocPad screw mount base (ADLOC115W). You can attach the screw mount base to the surface from above, then
screw the mounting pole to the base. There is no need to access the surface from behind to install in this case.
N
O
TE
!
www.
armour
dog.com
armourdog® is a trademark of Lente Designs® Ltd. All other trademarks are acknowledged.
Lente Designs Ltd, ‘The Barn’, 110B London Road, Aston Clinton, BUCKS, HP22 5HS
Company Reg: 8643511. VAT Reg: GB 163 3391 82
+44(0)1296 707101 [email protected]
Installation guide
1) Secure the mounting tube
Line up the mounting tube and mark where you want to install it. Drill 4
screw holes and the central charge cable hole through the surface. You
can use the round metal strengthening plate as a template to mark on
the surface where you need to drill. Screw the four double headed
screws into the tube all the way, then push the tube and screws into
the drill holes.
Remember the power cable has to run through the hole
in the middle of the tube, so ensure the middle drill hole is wide
enough to pass a USB head through.
Secure the pole from the other
side of the surface with the strengthening plate and the bolts provided
as per the diagram.
2? Attach the enclosure to the tube
Secure the enclosure chassis to the
mount tube with the 4 x screws
provided. Make sure you install the
round metal strengthening plate behind
the screws as highlighted in the picture.
This is now a good time to ensure your
charge cable is fed through the holes
and in place
3) Install the fit kit
Install the four corners of the
fit kit onto the predefined
pegs of the enclosure. Make
sure you install the corners
the correct orientation,
allowing for any indents for
power switches / power
cables etc.
4) Install the tablet
Connect the charging lead to the
tablet and slot your tablet into the
‘fit kit’. The tablet should fit
perfectly into the fit kit. If it is not,
check you have the fit-kit corners
the correct way round. If the
tablet doesn’t fit at all, it’s possible
you have a fit-kit for another tablet
brand. Give us a call.
5) Lay the face plate
over the tablet
Peel off the protective
covering on the faceplate.
Ley the plate on top of the
tablet, ensuring it’s on the
right way round. The
camera and home buttons
(if selected) should clearly
be in the correct place.
6) Install and lock the front metal
enclosure plate
There are two hooks on the underside
of the metal plate which should line up
the appropriate receptacles on the rear
part of the enclosure. Slot these in and
pivot the rest of the metal plate down
onto the enclosure, then press the
barrel lock in to lock the face plate in
place. Insert the key into the barrel lock
and rotate to release the lock and allow
the metal plate to be removed again.
Hook the metal front plate here.
