Pioneer RCS-404H, Operating Instructions Manual

Page: 134 / 152

The Initial Setup menu 15
134
En
Additional information about the TV system
settings
About the input line system
This recorder is compatible with PAL, SECAM, 3.58 NTSC
and PAL-60 TV systems. The Input Line System and Input
Colour System settings determine how the recorder
treats incoming video signals from an external input or
the built-in TV tuner.
Please note the following points when changing the
input line system:
• When the current input is a built-in tuner channel
preset, changing the input line system will usually
also affect the input line system of the
AV2 (INPUT 1/
DECODER) input. However if the AV2/L1 In setting is
set to
Decoder
, then the L2 input is affected instead.
• If, when the Input Line System setting is changed, the
screen goes blank (due to incompatibility with your
TV), you can switch back by pressing and holding the
front panel
STOP
button then pressing
OPEN/
CLOSE (also front panel) while the recorder is
stopped.
• When you switch the Input Line System setting the
Copy List is erased. If you switch the setting using the
STOP button and OPEN/CLOSE buttons as
described above, there is no confirmation, so please
use with care.
• You can’t mix recordings of different TV line systems
on the same disc.
• When you change this setting, the Input Colour
System
setting also changes (see below).
About NTSC on PAL TV
Depending on the Input Line System setting and the
NTSC on PAL TV setting, the signal format output when
the recorder is stopped varies as shown in the table
below.
Front Panel Display On •
The time is shown in the front panel display when the recorder is in standby.
Off
The front panel display is switched off in standby (although it still lights dimly
when setting a timer recording).
Remote Control
Mode Recorder 1–3
(default: Recorder 1)
If you are using more than one recorder in the same room, set them to different
IDs. This setting sets the recorder ID; to change the remote controller ID, press
and hold
RETURN then press 1 , 2 or 3 to set. The remote will only control a
recorder with the same ID.
AV. Link This Recorder
Only •
Signals received through the AV input when the recorder is in standby are not
passed through to the AV output.
Pass Through Signals received when in standby are passed though to the output for connected
devices. (Note that during EPG data download, the EPG data is not passed
through.)
When set to Pass Through , make sure to set Power Save (page 128) to Off .
DivX VOD Registration Code Use to display the recorder’s DivX registration code. See DivX video compatibility
on page 47 and
DivX® VOD content
on page 47.
Set Preview
(HDD only)
Quick Preview • When in the Disc Navigator, the thumbnail video plays short excerpts from
throughout the selected title. (Note that edited titles that will play normally from
the beginning.)
Normal
The thumbnail video plays from the beginning of the title.
Setting Options Explanation
Input Line
System NTSC on PAL
TV Output when
stopped
625 System Off PAL
On PAL
525 System Off NTSC
On PAL–60