Pioneer ELITE VSX-LX505, Instruction Manual

Page: 11 / 212

11
Part Names
Front Panel
I
F G A
B
C D E
H J K L M I
A
INPUT SELECTOR dial : Switch the input to be
played.
B
FL OFF indicator : Lights up when the display is
turned off by repeatedly pressing the DIMMER
button on the remote controller.
C
Display ( → p13 )
D
NETWORK indicator : This lights when "NET"
is selected with the input selector and the unit
is connected to the network. Lights up when
any of the following functions is working or
enabled in standby state of this unit. When this
indicator is lighting, the power consumption in
standby state increases, however, the increase
in power consumption is minimized by entering
the HYBRID STANDBY mode where only the
essential circuits operate. It does not light when
ZONE 2/ZONE 3 is on, however.
– HDMI CEC ( → p142 )
– HDMI Standby Through ( → p142 )
– USB Power Out at Standby ( → p144 )
– Network Standby ( → p145 )
– Bluetooth Wakeup ( → p145 )
E
Remote control sensor : Receives signals from
the remote controller.
• The signal range of the remote controller is
within about 16´/5 m, at an angle of 20° on the
perpendicular axis and 30° to either side.
F
Advanced MCACC indicator : This lights when
you have enabled the speaker calibration made
with MCACC. ( → p153, p170 )
G
MASTER VOLUME
H
STANDBY/ON button : When the power is
turned on, the periphery of the button lights up.
It also lights up when ZONE 2/ZONE 3 is turned
on.
I
Front flap
J
PHONES jack : Headphones with a standard
plug (ø1/4" / 6.3 mm) are connected.
K
SETUP MIC jack
: Connect the supplied speaker
setup microphone. ( → p153, p170 )
L
USB port : A USB storage device is connected
so that music files stored in it can be played.
Supply of power to USB devices while in the
standby mode is not supported. (
→ p114
)
M
AUX INPUT HDMI jack : Connect a video
camera, etc. using an HDMI cable. ( → p69 )