14
Rear Panel
9.
SIGNAL GND terminal
: Connect the ground
wire of the turntable.
10.
RS-232C port
: Connect a home control system
equipped with an RS-232C port. For adopting
a home control system, contact the specialized
stores.
11.
AUDIO IN jacks
: Input AV component audio
signals with an analog audio cable.
12.
IR IN port
: Connect a remote control receiver
unit. (
→p55
)
13.
ZONE 2 PRE/LINE OUT jacks
: Output audio
signals with an analog audio cable connected
to an integrated amplifier in a separate room
(ZONE 2).
ZONE B LINE OUT jacks
: Simultaneously
output the same audio source as the speakers
(ZONE A) connected to this unit by connecting
this unit to wireless headphones, wireless
speaker transmitter, etc., using an analog audio
cable.
14.
SUBWOOFER PRE OUT jacks
: Connect a
powered subwoofer with a subwoofer cable. Up
to two powered subwoofers can be connected.
The same signal is output from each of the
SUBWOOFER PRE OUT jacks.
15.
12V TRIGGER OUT jack
: Connect a device
equipped with a 12V trigger input jack to enable
power link operation between the device and this
unit. (
→p56
)
16.
SPEAKERS terminals
: Connect speakers with
speaker cables. (Support banana plugs. Use a
plug 4 mm in diameter. Y plug connection is not
supported.)
