9
PREP
ARA
TION
PREP
ARA
TION
PREP
ARA
TION
Before You Start
8 inches (20 cm)
Receiver
Installing the Receiver
Opening the Front Panel
To open the front panel push gently on the lower third of the panel with your
finger.
Remote Control Cushions
Apply the cushions to the feet of the remote control as shown in the diagram right.
Operating range of remote control unit
The area in which you can use the remote control to operate the VSX-49TXi is fairly large. To use, point the
remote control toward the remote sensor on the front panel of this unit while within the range shown below.
Remote control may not function properly if:
• There are obstacles between the remote control and
the remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver located near a device emitting infrared
rays.
• Operated simultaneously with another remote control
which uses infrared rays.
Lock Switch
Touch pen
30
30
23 feet (7m)
The Touch Pen & Lock
The touch pen is located in the back right-hand corner of the remote
control. Take it out by sliding your finger along the bottom right edge
of the remote control and then grasping the pen with thumb and
forefinger.
The lock switch is located in the top right-hand corner on the back of
the remote control. When this switch is set to LOCK you can’t use
the buttons on the remote control. This is helpful to prevent you from
mistakenly pushing a button. For normal use keep the switch set in
USE.
CAUTION!
• Do not cover this unit in any way, for exam-
ple with a sheet or piece of cloth. This would
prevent proper heat dispersal.
• Do not any place object directly on top of
this unit. This also would prevent proper heat
dispersal.
• Be sure to leave adequate ventilation space
around the amp! When installing in a rack,
shelf, etc., be sure to leave more than 8
inches of space above the receiver.
