85
OPERA
TION
Using Other Functions
• You can also control PIONEER components (and those made by other manufacturers) by pointing the
receiver's remote control directly at the respective component. This type of operation does not re-
quire control cords. All you have to do is recall the appropriate the stored settings (see p. 58 – 59).
• If you use a remote control hooked up via the CONTROL IN jack with a control cord, you won't be able
to use this unit's remote control.
• Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the
IR receiver remote sensor window.
• The tuner cannot be tuned to more than one station at a time. Therefore, changing the station in one
room also changes the station in the other room. Please be careful not to change stations when
recording a radio broadcast.
• The volume levels of the main and sub rooms are independent.
• When more than one remote control signal is transmitted at the same time, the receiver does not
operate.
• When operating MULTI-ROOM & SOURCE with the MULTI-ROOM PRE OUT jacks connected to a
SUB room amplifier which bears the PIONEER
Î
mark and has a remote sensor, both the IR receiver
and the amplifier may receive remote control commands (making correct operation impossible). In
this case, place the IR receiver and amplifier apart from each other, and point the remote control
directly at the IR receiver during operation.
• If you plan to leave the MULTI ROOM feature off for a lengthy period please turn off the power in both
the SUB and MAIN rooms. Make sure the STANDBY indicator turns red and the MR&S indicator goes
off.
• If you send the SYSTEM OFF command from the SUB room by remote control, the power of both
rooms will go off. Please be careful when making a recording in the MAIN room.
The PIONEER SR System
Connecting an optional control cord allows you to operate other PIONEER components simply by pointing the
receiver's remote control at the remote sensor on the front panel of the receiver. The receiver then sends the
remote control signals to the other devices via the CONTROL OUT terminal.
memo
memo
OUT
IN
CONTROL
OUT
IN
CONTROL
PIONEER component
bearing the
Î
mark.
Remote Control
To CONTROL IN
terminal of another
PIONEER component
bearing the
Î
mark.
Receiver
