Connecting up
02
18
En
Connecting to a cable box,
satellite receiver or digital
terrestrial receiver
If you have a cable, satellite or digital
terrestrial receiver with a built-in decoder,
connect it to this recorder and your TV as
shown on the following page.
1
If you are
using a separate decoder box for your cable/
satellite TV, set up following the instructions
on the next page.
Using the setup on this page you can:
• Record any channel by selecting it on
the cable box, satellite receiver or digital
terrestrial receiver.
• Change channels and set timer
recordings on the external receiver using
the GUIDE Plus+™ system (via the
G-LINK™ cable, and after setting up).
Important
• Do not connect this recorder to your TV
‘through’ your VCR, satellite receiver or
other component. Always connect each
component directly to your TV or AV
amplifier/receiver.
• When using the GUIDE Plus+ system to
make a timer recording from an external
receiver, make sure that the external
receiver is switched on.
1
Connect RF antenna cables as shown.
This enables you to watch and record TV
channels.
2
Use a SCART cable (not supplied) to
connect the AV1(RGB)-TV AV connector
to a SCART AV connector on your TV.
This enables you to watch discs.
3
Use another SCART cable to connect
the AV2(INPUT 1/DECODER) AV
connector to a SCART AV connector on
your cable box/satellite/digital terrestrial
receiver.
This enables you to record scrambled TV
channels.
Note
1 The diagram shows SCART video connections, but you can alternatively use any of the other audio/video
connections.
TV
Satellite dish/
antenna/cable TV
wall outlet
Cable/Satellite/
Digital Terrestrial
receiver
AC IN
DIGITAL
OUT
CONTROL
G-LINK
COAXIAL
IN
S-VIDEO
VIDEO
AUDIO
L
R
COMPONENT
VIDEO OUT
Y
P
B
P
R
ANTENNA
IN
OUT
OUTPUT
AV 1 (RGB) – TV
AV 2 (INPUT 1/DECODER)
S-VIDEO
VIDEO
AUDIO
L
R
INPUT3
HDMI OUT
SCART AV
CONNECTOR
SCART AV
CONNECTOR
ANTENNA
IN
ANTENNA
IN (RF IN)
ANTENNA
OUT
ANTENNA
OUT
ANTENNA
IN
1
1
2
3
1
4
DVR645H_WY_EN.book 18 ページ 2006年7月5日 水曜日 午前10時25分