Pioneer AVIC-X1BT, Operation Manual

Page: 109 / 155

107
Chapter
8
Cu
st
om
ising t
h
e A
u
dio So
u
rce
S
etting
AV
Initial Settings
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for navigation system.
(1) Function display
Shows the function names.
1
Touch the source icon and then touch
“SOURCE OFF” to turn source off.
When the source icon is not displayed, you
can display it by touching the screen.
2
Touch “A.MENU” and then touch
“INITIAL” to display the function names.
The function names are displayed and opera-
ble ones are selected.
When “
A.MENU ” is not displayed, you can
display it by touching the screen.
To return to the previous display, touch
“
BACK ”.
To return to the display of each source, touch
“
ESC ”.
Setting the FM tuning step
Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA is on, the tuning
step automatically changes to 100 kHz. It may be
preferable to set the tuning step to 50 kHz when
AF is on.
1
Touch “FM STEP” in the INITIAL menu.
Each time you touch “ FM STEP ” will switch
the FM tuning step between 50 kHz and 100
kHz while AF or TA is on.
❒
The tuning step remains at 50 kHz during
manual tuning.
Switching Auto PI seek
The unit can automatically search for a different
station with the same programming, even during
preset recall.
1
Touch “AUTO PI” in the INITIAL menu.
Touching “ AUTO PI ” switches between “ ON ”
and “ OFF ”.
Switching the auxiliary setting
It is possible to use auxiliary equipment with navi-
gation system as the one of source. Activate the
auxiliary setting when using auxiliary equipment
connected to the navigation system.
1
Touch “AUX” in the INITIAL menu.
Touching “ AUX ” switches between “ ON ” and
“ OFF ”.
➲ Selecting AUX as the source ➞ Page 99
Selecting the illumination col-
our
The navigation system is equipped with two illu-
mination colours, green and red. You can select
the desired illumination colour.
1
Touch “ILLUMI” in the INITIAL menu.
Touching “ ILLUMI ” switches between
“ GREEN ” (green) and “ RED ” (red).
Setting the rear output and sub-
woofer controller
This navigation system’s rear output (rear speaker
leads output and RCA rear output) can be used for
full-range speaker (
REAR SP FULL ) or sub-
woofer ( REAR SP SUB W ) connection. If you
switch the rear output setting to the REAR SP
SUB W , you can connect a rear speaker lead
directly to a subwoofer without using an auxiliary
amp.
Initially, the navigation system is set for rear full-
range speaker connection (
REAR SP FULL ).
When rear output is connected to full range
speakers (when
REAR SP FULL is selected),
you can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass filter,
(1)
Initia
l Settings