HUNTER-PRO 896 Installation Guide
37
4 P
ROGRAMMING
B
ASICS
4.1 General
The HUNTER-PRO 896 is supplied with factory default parameters. In most installations
you will have none or few parameters to program, except for user-specific parameters,
such as telephone numbers, zone names etc.
4.2 Methods
There are few ways to program the HUNTER-PRO 896:
1.
Locally with the PIMA Fast Programmer PRG–896. The PRG-896 can have 7
different programs, each with a preset of parameters. It connects to any LCD
keypad.
2.
Locally or remotely (via telephone or GSM) with COMAX, PIMA control &
communicate software.
3.
Directly with the keypad.
4.2.1
Fast Programming with PRG-896
PRG-896 is based on ROM chip. It holds parameters that have been uploaded with
COMAX and then downloaded to a system at a site. PRG-896 can only be programmed
with an RXN LCD Keypads. It connects to RJ-11 connector on the keypad PCB. See the
fast programming procedures on section.
5.9.3.
-V
+V
IN
OUT
TM
PR 2
TM
PR 1
ON
/
OFF
AL
AR
M
-S
1
S
2
C
N
.O
N
.C
-
SIREN
RELA
Y
SMO
K
E
-+
IN
OUT
F4
F3
Fast Load
ENTER/NEXT/END
RXN-410
KEYBOA
RD
Control
Panel
KEY
PRG-896
Figure 24 - Connecting LCD Keypad to Control Panel and PRG-896
4.2.2
Local Programming with COMAX
COMAX gives a quick and easy way to upload sets of parameters in the service station
and download them later on at a customer site. Connecting the PC with the COMAX to
the control panel is done using LCL-11A adaptor.