Pilous ARG 250 plus S.A.F., Instruction Manual

Page: 17 / 47

5.6. Hydraulic unit
Hydraulic unit is placed inside machine base. Enables arm lift up after cut is finished, arm feed into cut and vice opening
and closing. The HYDRAULIC UNIT - START button together with MAIN SWITCH on activates the electrical and hydraulic
systems of the machine.
A
A
2
1 1
2
A
A
2
1 1
2
VICE
(only in manual mode)
This switch enables vice jaw closing or opening
The cutting speed can be fluently changed using the control knob for the bandsaw speed (via the frequency
converter) on the control panel
The selected value is regularly displayed (see technical data)
m/min
OVLADAČ RYCHLOSTI PILOVÉHO PÁSU
DISPLAY
Press the button to start lowering the arm. At the same time, the clamping unit must be closed (switch in
position 1)
START
(only in manual mode)
BEZPEČNOSTNÍ TLAČÍTKO SAFETY
If during the operation there is any activation of a safety element – disconnection of the switch on the belt
cover or activation of the TOTAL STOP button, the backlit SAFETY button shines and the control power
circuits are disconnected. After restoration of the activity of the machine it is necessary to remove the reason
for disconnection (close the cover, unlock TOTAL STOP) and consequently press the SAFETY button.
During each running of the saw, activation of the main switch and the TOTAL STOP button, the SAFETY
signal lamp must shine, by consequently pressing the signal lamp is PFF and, consequently, it is possible to
set the hydraulic aggregate and to control the saw. A non shining signal lamp means failure (see Chapter 9).