5.7.1. Vice clamping pressure setting
Hydraulic unit is equipped with PRESSURE REGULATION. The PRESSURE REGULATION enables required clamping pressure of
the vice according to the workpiece character in the range of 13-35 bars. By turning the PRESSURE REGULATION to the left the
pressure decrease, to the right for pressure increase (see picture). The set pressure is showed on the pressure indicator. If less than
13 bar pressure is set, the safety pressure switch P.S. will not switch and the saw band will not start.
5.8.Arm uplift height setting
Steps for setting:
Saw arm is in the down end position.
Loose arm uplift lever and on the
scale set requested uplift approx. 5 - 10 mm above the workpiece) and
tighten the lock lever.
Saw arm is above the down end position.
Switch the arm uplift switch
to position 0. Press START button. Valve will open and the arm will move
to down end position. Loose the arm up lift lever and set on the scale
requested uplift ( approx. 5 - 10 mm above the workpiece) and tighten the
lock lever.
ARM UP LIFT END SWITCH
ARM UP LIFT BACKSTOP
LOCK LEVER
ARM UPLIFT
SETTING SCALE
This system enables arm uplift height setting exactly above the workpiece. This is very useful when cutting in bigger series for saving
cutting cycle time.
FILLING HOLE WITH DIPSTICK
VICE VALVE EV3
PRESSURE SWITCH
OF SAW ARM EV2
SYSTEM PRESSURE ADJUSTMENT
UNQUALIFIED INTERVENTION NOT ALLOWED!
SAW ARM
PRESSURE VALVE EV1
PRESSURE GAUGE
VICE PRESSURE
REGULATION
VICE PRESSURE SWITCH P.S.
(WITH COVER)
Ev1
Ev2
Ev3
FILTER CARTRIDGE
Summary of Contents for ARG 250 plus S.A.F.
Page 34: ...11 3 2 Table turning table pivot and vice assembly ARG 250 plus S A F ARG 300 plus S A F...
Page 44: ......
Page 45: ......
Page 47: ......
