Pilous ARG 250 plus S.A.F., Instruction Manual, Page: 23 / 47

7. Putting into operation
7.1. Safety Control
Is everything in perfect condition as far as technical safety is concerned?
Have all covers been properly fitted?
7.2. First cut
1) TOTAL STOP button must be unblocked. Switch on the main switch and the HYDRAULIC UNIT START button, machine will be
activated.
2) Set correct cutting angle (see Chapter 5.5.1.)
3) Set needed arm up end position according to the workpiece (see Chapter 5.8.)
4) Into vice (N) enter the workpiece and set requested length.
5) Set the left guiding head (R) 5 - 10 mm far from the maximal workpiece dimension.
6) Close completely the regulation valve (see Chapter 5.9.)
7) Set the band cutting speed (see Chapter 6.6.)
On the control panel select the MANUAL or AUTOMATIC mode (see Chapter 5.5.)
Caution! Danger of injury!
The band is not covered in the machining zone.
Switch the MODE switch to MANUAL.
By switch VICE, clamp the workpiece.
Start the saw band by pressing the green button for band
start.
With green exciter START button activate the arm down
feed system.
By gradual slacking of regulation valve set the optimal arm
feed speed into cut (see Chapter 5.9.).and by controlling
the feed speed with regulation valve finish the cut.
After cut is finished, the arm will move automatically up to
upper set position (or the arm remains in the lower position
if the switch is in the position 0).
MANUAL MODE
Switch the MODE switch to position AUTOMAT mode.
By green START button, cutting cycle is activated (material is
clamped, band drive starts, band feed into cut activated)
By gradual slacking of regulation valve, the optimal arm feed
into cut speed is set (see Chapter 5.9.). Cut will be finished.
After cut is finished the arm will move automatically to upper
set position (or the arm remains in the lower position if the
switch is in the position 0).
AUTOMATIC MODE
8)
9)
10)
11)
12)
13)
8)
9)
10)
11)
N
R