Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com
27
8
how to operate the digital amplifier 24DV40
8.1 common introduction
The digital amplifier
24DV40
has designed to control the D-actuators from
piezosystem jena
. it
can be used with actuators with or without integrated position sensor. Actuators with integrated
position sensor allows positioning without creeping or hysteresis by digital PID loop control. The
amplifier is controlled by USB only and reach a resolution of 16-bit. piezosystem jena supports
driver for Windows® operating systems.
The integrated digital loop controller comes as PID controller, additionally a slew rate limiter and a
low pass filter 4
th
order for set point filtering are available.
The digital amplifier
24DV40
allows the interchangeability from D-actuators and amplifier. All
needed information is stored on the ID-chip, located in actuator connector, and will read by piezo
controller after system start.
8.2 connections
connector
actuator
USB
interface
Power supply
connector
(both in parallel
circuit)
LED
indicator
