PI M-605 Series, User Manual

Page: 14 / 35

5 Installation
10 Version: 1.2.0 MP45E M-605 High-Precision Linear Stage
−
Hex wrench
Mounting the positioner onto a surface
1. Place the positioner on the surface so that the corresponding mounting holes in the
positioner and the surface are in line.
2. Tighten all screws in the mounting holes selected.
3. Check that the positioner is affixed firmly to the surface.
5.3 Affixing the Load to the M-605
Requirements

You have read and understood the general notes on installation (p. 9).

You have mounted the stage onto a surface properly (p. 9).

The stage is not connected to the controller.

You have prepared the load so that it can be affixed to the mounting holes on the upper
platform (p. 24).
Tools and accessories

At least 2 metric screws M4x35

Hex wrench; in the scope of delivery (p. 5)
Affixing the load
1. Align the load so that the selected mounting holes in the platform can be used to affix
it.
2. Use the screws to affix the load on the selected mounting holes in the platform.
3. Check that the load is affixed firmly to the platform of the positioner.
5.4 Connecting the M-605 to a Controller
Requirements

You have read and understood the general notes on installation (p. 9).

You have installed the controller.

You have read and understood the user manual for the controller.

The controller is switched off.
Tools and accessories

Motor cable; in the scope of delivery (p. 5)