8
Maintenance
NOTICE
Damage due to improper maintenance!
Improper maintenance can lead to misalignment and failure of the L-417.099232B.
►
Loosen screws only according to the instructions in this manual or the instructions of our
customer service department (p. 24)
.
8.1
Maintenance Run
The maintenance run serves the purpose of distributing the existing lubricant.
The following intervals for the maintenance run depend on the operating conditions and the
period of use:
■
After 200 operating hours or at least after one 1 year
■
If the L-417.099232B is moved over a small travel range (<40 mm) during industrial
operation: After every 2000 motion cycles
Performing a Maintenance Run
1. Make sure that collisions between the L-417.099232B, the load to be moved, and the
surroundings are not possible over the entire travel range of the L-417.099232B. If
necessary, remove the load from the motion platform of the L-417.099232B for the
maintenance run.
2. Perform a maintenance run over the entire travel range:
a) Command the L-417.099232B to the end of a travel range and from there to the
opposite end of the travel range (see manual for the electronics).
b) If necessary: Command the L-417.099232B to a position, where the load can be
mounted onto the motion platform again and
mount the load back onto the
L-417.099232B (p. 16)
.
8.2
Relubricating
The L-417.099232B is equipped with a grease nipple for relubricating the drive screw. For
continuous industrial use, the lubrication intervals and the lubrication quantity must be
determined individually.
Use Klüber STABURAGS NBU 12/300 KP only as lubrication for the L-417.099232B.
If you have any questions on relubricating, contact our
customer service department (p. 24)
.
8.3
Moving the Motion Platform by Hand
It can be necessary to move the motion platform manually to provide access to mounting
holes for mounting screws in the base body of the positioner.
Requirements
✓
You have disconnected the L-417.099232B from the electronics.
Moving the Motion Platform by Hand
1. Apply the
supply voltage (p. 36)
to the
holding brake connectors (p. 33)
.
➔
The holding brake is released.
2. Exert a steady force on the motion platform to move it.
8 MAINTENANCE
L417M0004EN
‒
11/21/2018
20
M O T I O N | P O S I T I O N I N G
