phyCORE-TriCore Development Board
©
PHYTEC Meßtechnik GmbH 2009 L-730e_0
37
1.3.11
Pin Header Connectors X10
Connector X10 supplies 5 VDC at pin 1 and provides the phyCORE-
TriCORE Development Board GND potential at pin 2.
The maximum current draw depends on the power adapter used.
1.3.12
USB Wiggler connector X11
The phyCORE-TriCORE Development Board provides the USB jack
X11 to enable access to the JTAG of the phyCORE-TC1130 or
phyCORE-TC1796 via the DAS Server JTAG over USB Chip.
Make sure the Latest DAS released is installed on your PC.
Please contact your prefered debug vendor for support of DAS.
If DAS is installed on the PC, the driver for the USB Wiggler will
automatically be installed after connecting the The phyCORE -
TriCORE Development Board with the PC.
Two status LEDs for USB Wiggler status are provided:
LED D4 (green): LED is ON if a working connection is established
with the DAS Server on the PC
LED D6 (red):
LED is ON when DAS Server is disconnected after
being connected
Caution:
When using USB Wiggler connector X11, make sure there is NO
or tristated connection on the JTAG connector of the
phyCORE-TC1130 (X2) or phyCORE-TC1796 (X1)
and the OCDS2 connector phyCORE-TriCORE Development Board
is NOT used
