phyCORE-TriCore Development Board
1.3
Functional Components on the phyCORE-TriCORE
Development Board
This section describes the functional components of the
phyCORE-TriCORE Development Board supported by the phyCORE-
TC1130 or phyCORE-TC1796 and appropriate jumper settings to
activate these components. Depending on the specific configuration of
the phyCORE-TC1130 or phyCORE-TC1796 module, alternative
jumper settings can be used. These jumper settings are different from
the factory default settings shown in
and
Figure 6
and
enable alternative or additional functions on the phyCORE-TriCORE
Development Board depending on user needs.
1.3.1
Power Supply at X1
Caution:
Do not use a laboratory adapter to supply power to the Development
Board! Power spikes during power-on could destroy the phyCORE
module mounted on the Development Board! Do not change modules
or jumper settings while the Development Board is supplied with
power!
Permissible input voltage: +/-5 VDC regulated.
The required current load capacity of the power supply depends on the
specific configuration of the phyCORE-TC1130 or phyCORE-
TC1796 mounted on the Development Board as well as whether an
optional expansion board is connected to the Development Board. An
adapter with a minimum supply of 1.5 A is recommended.
Figure 7:
Connecting the Supply Voltage at X1
10
©
PHYTEC Meßtechnik GmbH 2009 L-730e_0
+5VDC
GND
≥
1.5 A
center hole
1.3mm
3.5mm
--
+
polarity:
