phyCORE-TriCore Development Board
22
©
PHYTEC Meßtechnik GmbH 2009 L-730e_0
1.3.7
RJ45 Ethernet Connector X7
The phyCORE-TriCORE Development Board provides the Ethernet
RJ45 jack with integrated magnetic at X7 to enable immediate
connection of the phyCORE-TC1130 or phyCORE-TC1796 to an
10/100 Mbit/s Ethernet network. Two status LEDs for LINK and LAN
are provided to display network status. The following jumper settings
are required:
Jumper Setting
Description
JP10
1 + 2
3 + 4
5 + 6
7 + 8
The Ethernet transformer module is connected to the
Ethernet signals on the phyCORE-TC1130 or
phyCORE-TC1796
JP2
open
configuration for phyCORE-TC1130 module
closed
configuration for phyCORE-TC1796 module
JP3, JP4,
open
configuration for phyCORE-TC1796
and phyCORE-TC1796
JP5, JP6
open
configuration for phyCORE-TC1130 module
closed
configuration for phyCORE-TC1796 module
JP11
1+2
configuration for phyCORE-TC1796 module
2+3
configuration for phyCORE-TC1130 module
Table 11:
JP2-6 ,JP10,JP11, Configuration of the Ethernet Interface
1.3.8
Programmable LED D3
The phyCORE-TriCORE Development Board offers a programmable
LED at D5 for user implementations. This LED can be connected to
port pin P2.11 of the phyCORE-TC1130 or P8.0 of the phyCORE-
TC1796 which is available via signal GPIO0 (JP18 = closed). A low-
level at port pin causes the LED to illuminate, LED D5 remains off
when writing a high-level to the appropriate port pin.
Jumper Setting
Description
JP18
closed
Port pin P2.11 (GPIO0) of the TC1130 controller
controls LED D5 on the Development Board
closed
Port pin P8.0 (GPIO0) of the TC1130 controller
controls LED D5 on the Development Board
Table 12:
JP18 Configuration of the Programmable LED D3
