Phytec phyCORE-MPC5200B tiny, Hardware Manual

Page: 65 / 104

The phyCORE-MPC5200B tiny on the Development Board
©
PHYTEC Messtechnik GmbH 2006 L-678e_0
57
+5 VDC
GND
≥
1500 mA
Center Hole
1.3 mm
3.5 mm
-- +
Polarity:
Figure 14: Connecting the Supply Voltage at X1
Caution:
When using this function, the following jumper settings are not
allowed:
Jumper Setting Description
2 + 3 5 V as primary main supply voltage
for the phyCORE-MPC5200B tiny
JP9
open phyCORE-MPC5200B tiny not connected to
primary main supply voltage
2 + 3 5 V as secondary main supply voltage
for the phyCORE-MPC5200B tiny
JP16
open phyCORE-MPC5200B tiny not connected to
secondary main supply voltage
Table 15: JP9, JP16 Improper Jumper Settings for the Main Supply Voltages
Setting Jumper JP9 to position 2+3 configures a primary main power
supply to the phyCORE-MPC5200B tiny of 5 V which could destroy
the module. Setting Jumper JP16 to position 2+3 configures a
secondary main power supply to the phyCORE-MPC5200B tiny of
5 V which also can damage the module. If Jumper JP9 and JP16
remain open, no primary and secondary main power supply is
connected to the phyCORE-MPC5200B tiny. These jumper settings
should therefore not be used.