Contents
©
PHYTEC Messtechnik GmbH 2011 L-710e_5
Index of Tables
Table 1:
Pin-out of the phyCORE-Connector X1............................9
Table 2:
Jumper settings ..............................................................24
Table 3:
Power supply for the minimum circuit.............................28
Table 4:
i.MX27 default power input voltages...............................28
Table 5:
VBKUP2 Voltage Settings ..............................................29
Table 6:
Default PUMS for i.MX27 module...................................31
Table 7:
Boot Modes of i.MX27 module .......................................32
Table 8:
i.MX27 memory map ......................................................33
Table 9:
Compatible NOR Flash devices .....................................34
Table 10:
Compatible NAND Flash devices ...................................34
Table 11:
JN1/2,RN31/32 NAND Flash bit width selection.............35
Table 12:
U12 EEPROM I²C address via J13, J15, and J16..........36
Table 13:
EEPROM write protection states via J1..........................36
Table 14:
RN30 UART1 signal routing ...........................................38
Table 15:
Fast Ethernet controller memory map ............................40
Table 16:
JTAG connector U15 signal assignment ........................43
Table 17:
Jumper settings of PMA-002 ..........................................53
Table 18:
PMA-002 mapping list ....................................................54
Table 19:
Jumper settings for i.MX27 power supply via
power plug ......................................................................64
Table 20:
Jumper settings for i.MX27 power supply via POE ........65
Table 21:
Jumper settings for i.MX27 power supply via battery .....66
Table 22:
CAN interface jumper settings........................................68
Table 23:
x_BOOT_MODE0 selection............................................70
Table 24:
x_BOOT_MODE1 selection............................................70
Table 25:
x_switch ..........................................................................70
Table 26:
CF interface jumper settings...........................................72
Table 27:
SD/MMC interface jumper settings for i.MX27 module ..73
Summary of Contents for phyCORE-i.MX27
