The phyCORE-i.MX on the Carrier Board
©
PHYTEC Messtechnik GmbH 2011 L-710e_5
51
14.2
phyMAP-i.MX27
The phyMAP-i.MX27 is responsible for mapping the signals from the various phyCORE-i.MX modules
to the phyCORE-i.MX Carrier Board. Signal differences at the connectors on the phyCORE-i.MX
modules, along with signal differences between the phyCORE-i.MX module connectors and i.MX
Carrier Board connector do not allow for direct connection of the phyCORE-i.MX modules into a
single, standardized Carrier Board. To allow for the use of a single Carrier Board, despite the signal
differences, the phyMAP-i.MX27 board serves as the gateway to properly map signals from the i.MX
Carrier Board Molex connectors to the various phyCORE-i.MX module connectors.
J2
X1
J1
X1
Figure 14: phyMAP-i.MX27 top view
Summary of Contents for phyCORE-i.MX27
