Development Board for phyCORE-MPC555
4
PHYTEC Meßtechnik GmbH 2000 L-525e_2
The Development Board offers the following features:
•
Reset push-button, configurable via jumper for different Reset
signals
•
IRQ push-button, configurable via jumper for different interrupts
•
Wake-Up push-button
•
Boot jumper to select internal or external FLASH memory
•
Jumper to enable the programming voltage for internal FLASH
memory
•
Reset jumper to choose between internal and external Reset
configuration
•
two software programmable LED’s (red/green)
•
LED’s for power monitoring
•
LED to monitor debug or run mode
•
power supply for unregulated input voltage from 7 V to 13 V. It
supplies reg5V, +3.3V for the phyCORE-MPC555.
Addi5V is created for the VG96-connector.
•
VG-96 connector with all I/O-signals of the MPC555
•
two standard width pin header rows (3x54) which provide all
phyCORE-MPC555 signals
•
two DB-9 sockets for RS-232 interface
•
two DB-9 plugs for two separate CAN interfaces with configurable
terminating resistors
•
DB-25 plug for BDM interface to support direct connection to PC
printer-port
•
2 x 5 standard width pin header rows to support other BDM-
interfaces
