Photron Fastcam BC2 HD, Hardware Manual

Page: 23 / 83

11 FASTCAM BC2 HD Hardware Manual
2.2.6. RS-422 Serial Control
The system supports operation with serial control via an RS-422 connection through the
[KEYPAD] connector.
By setting the [STATUS OUT] menu to ON, the system status can be output via the serial
connection. Check the command list for details.
A cable is not offered as an accessory. When using RS-422 control, construct a cable using the pin
diagram below for reference.
Keypad Pin Diagram
PT02A-12-10S (023)
Connector
name
Signal
Pin
no.
Camera body
connector model
name (manufacturer)
Cable connector
model name
(manufacturer)
Input
connector
+12V OUT A
SIGNAL GND B
RXD+ C
RXD- D
TRIGGER SW E
TXD- F
TXD+ G
POWER GND H
NC J
KEYPAD
NC K
PT02A-12-10S (023)
(Amphenol)
PT06A-12-10P (023)
(Amphenol)
Not
specified
When using the connector pins directly, refer to the chart above and ensure the wiring is correct.
Incorrect wiring can cause malfunction.
The voltage on pin A (+12V OUT) is used to power the remote controller, do not use it for other
purposes.
•
For inquires related to RS-422 serial control, see "7.1 Contacting Photron", page 70.
• Serial control commands are available as separate list of commands. Please contact Photron or the
dealer where the system was purchased regarding the command list.