Photon Focus MV0 CMOSIS Series, User Manual, Page: 80 / 111

13 Hardware Interface
$
%
&
'
'
&
%
$
,QGH[ =1U
(UVWIUHLJDEH
B
0DWHULDO
ELV
)UGLHVH8QWHUODJH
EHKDOWHQZLUXQV
DOOH5HFKWHYRU
.DQWHQRKQH$QJDEHQ
5DGLXVRGHU)DFHWWH
$OOJHPHLQWROHUDQ]HQ
0DW1U :HUNVWRII
%HQHQQXQJ
1DPH 'DWXP
(UVWHOOW
*HSUIW
1RUPLHUW
)UHLJHJ
1DPH 'DWXP $HQGHUXQJ ,QG
%ODHWWHU
3URMHNWLRQ
0DVVVWDE
)RUPDW
$
09'2*
1XPPHU
0X
)D[
7HO
&+/DFKHQ
$SSOLFDEOHIRUWKHIROORZLQJFDPHUDPRGHOV
Figure 13.1: Rear view of the GigE camera
13.5 Status Indicator (GigE cameras)
Six LEDs on the back of the camera gives information about the current status of the GigE
CMOS cameras. LED S0, S1 and S2 are configurable. It can be selected, which camera status
information is showed by these LEDs (see Section 7.2 for the available camera status signals).
LED P0, P1 and P2 show the status of the GigE connection and can’t be configured by the user.
LED designator Default function
LED S0 It pulsates, when the camera is not grabbing images. It means, the
intensity starts from dark and goes slowly to bright and slowly to dark
again.When the camera is grabbing images the LED blinks at a rate equal
to the frame rate. At slow frame rates, the LED blinks. At high frame rates
the LED changes to an apparently continuous green light, with intensity
proportional to the ratio of readout time over frame time.
LED S1 Indicates an active serial communication with the camera.
LED S2 dark, not used in default configuration
Table 13.3: Default LED S0, S1 and S2 configuration of the GigE CMOS cameras
LED designator GigE Function
LED P0 not used, always off
LED P1 On: acitivity; Off: no activity
LED P2 On: link; Off: no link
Table 13.4: Meaning of LED P0, P1 and P2 of the GigE CMOS cameras
.
80 of 111 MAN078 12/2018 V1.1