16
EN
09302
ALARM
When the alarm is armed, both the
SHOCK SENSOR
and the
ENGINE STOP
are activated.
The
SHOCK SENSOR
detects vehicle movements: if the vehicle is hit when the alarm is armed, the siren emits 3
beeps and the direction indicators flash 3 times.
If the vehicle is hit a second time, within 15 seconds, the siren sounds and the direction indicators flash for 25
seconds.
The
ENGINE STOP
prevents the vehicle from being started without authorisation.
When the system is armed, a maximum of 10 alarm cycles can be performed for each input (e.g. ignition), after
which the input that caused the alarms is disabled. It will be restored the next time the system is armed.
1. ALARM ARMING
Press button 1 (ARMING) on the radio remote control with the ignition off: the direction indicators will flash 3
times and the siren will emit 3 beeps. Wait 60 seconds (PRE-ALARM time) during which the alarm LED will remain
on. After 60 seconds the alarm will be armed and the LED will flash.
NB:If 10 movements are detected on the vehicle during the pre-arming phase, the shock sensor is excluded from the arming cycle to prevent
any anomalies from generating false alarms. The shock sensor will be restored at the next arming cycle. The exclusion is valid for all causes
of alarm (shock sensor, external input, ignition panel) and serves to prevent any anomalies from generating false alarms.
2. ALARM DISARMING
Press button 2 (DISARMING) on the radio remote control: the direction indicators will flash once, the siren
will beep once and the LED will go out.
If the ignition is not switched on within 21 seconds, the alarm is
automatically re-armed.
3. ALARM MEMORY
When you disarm the alarm, you will be warned by various acoustic signals, if the alarm sounded while you were
away. The number of beeps depend on what the system detects:
A. The siren beeps once = tampering of the lock ignition.
Unauthorised access to a protected compartment (external alarm input), power cut off.
B. The siren beeps twice = the vehicle is lifted or towed.
C. Siren emits three beeps = A + B
The alarm memory remains until the next time the alarm is armed.
4. MEMORY AT POWER-OFF
This function saves the system status and restores it at power-on even after a power cut off (battery backup),
regardless of its duration.
5. TEMPORARY DISABLEMENT OF THE SHOCK SENSOR
The system can be armed by temporarily disabling the shock sensor:
- Press button 1 (ARMING) on the radio remote control with the ignition off to arm the alarm.
- Press button 1 (INSERIMENTO) again within 20 seconds
- An acoustic signal confirms that the shock sensor has been disabled.
Note: The shock sensor detection function will be restored the next time the alarm is alarmed and disarmed.
