19
EN
09302
14. ANTI-HIJACK ALARM
Thanks to this function the system detects the presence of the driver while the vehicle is moving, by means of the
radio control signal. The system activates the siren when it does not detect the radio remote control signal within
60 seconds of the ignition being switched on. If the driver is not detected, after the 20-second alarm period, the
system will intermittently block the engine and the siren will continue to beep for 50 seconds until the vehicle
is permanently blocked. The cycle is repeated after a 20-second pause. To make the anti-hijack alarm work, it is
necessary to activate it on the main unit (following the procedure in the FUNCTIONS TABLE on page 21 and activate
user recognition on the radio remote control following the procedure in point 8).
15. DIRECTION INDICATOR ALARM
This safe-driving alarm can be activated by following the procedure given in the FUNCTION TABLE on page 21.
The system detects the direction indicators and, if they remain on for more than 24 seconds while the vehicle is
moving, the driver is notified with 8 beeps.
16. EXTERNAL INPUT ACTIVATION (SWITCHABLE POLARITY)
When the alarm is on, the siren will beep if an external input is detected.
The default setting is negative input.
You can change the polarity of the input by following the procedure in the FUNCTION TABLE on page 21.
ADJUSTMENT
17. SHOCK SENSOR SENSITIVITY ADJUSTMENTS
The SHOCK SENSOR sensitivity is set by default to level 5 on the range from 1 to 8 of the alarm.
Level 1 corresponds to the lowest sensitivity, level 8 to the highest sensitivity.
The sensitivity level can be changed by entering the "sensitivity adjustment" mode:
- when the alarm is disarmed, press button 2 (DISARM) on the radio remote control for 5 seconds,
the siren will emit 5 beeps to confirm access to the sensitivity adjustment mode.
- Press button 3 (MUTE) on the radio remote control to increase the sensitivity by one level.
To confirm the set level, the siren will beep the same number of times as the set sensitivity level and, at the same
time, the indicators will flash.
- To confirm the required sensitivity level and exit the sensitivity adjustment mode press button 2 (DISARMING).
18. SIREN VOLUME ADJUSTMENT
If necessary (e.g. the vehicle is parked in areas where excessive noise must be avoided) the volume of the siren can
be lowered. When the alarm is armed, press button 3 (MUTE) on the radio remote control once: the siren will
sound twice with the direction indicators flashing to indicate the volume is decreasing.
NB: this setting only applies to the current alarm cycle, once the alarm is disarmed the siren volume will
automatically be reset.
