20
EN
09302
RADIO REMOTE CONTROL
The two supplied radio remote controls are already paired with the alarm system.
A maximum of 2 radio remote controls can be combined with the system.
19. ENABLING USER RECOGNITION ON THE RADIO REMOTE CONTROL
Press button 3 (MUTE) 5 times within 5 seconds, the LED on the radio remote control will light up for 3 seconds
to indicate that user recognition is on.
From now on, the LED on the remote control will flash once every 10 seconds.
20. DISABLING USER RECOGNITION ON THE REMOTE CONTROL
Press button 3 (MUTE) 5 times within 5 seconds, the LED on the radio remote control will flash 5 times,
indicating that user recognition is off.
21. RADIO REMOTE CONTROL LOW BATTERY WARNING
If, after pressing button 2 (DISARMING) on the radio remote control, the direction indicators flash for a very long
time, the system is signalling to the owner that the battery should be replaced as soon as possible.
This warning signal is activated when the battery voltage of the radio remote control is below approximately 2.2V.
22. RADIO REMOTE CONTROL PROGRAMMING
Procedure for pairing a new radio remote control in case of replacement (the 2 supplied radio remote controls are
already paired).
When the alarm is disarmed, disconnect the backup battery, disconnect and reconnect the power supply to the
system, within 30 seconds, turn the key from OFF to ON 8 times, and stay ON.
After 3 seconds, the siren will emit a long beep and the system will enter the "programming radio remoote control
mode".
Press any button on the radio remote control: the siren will beep and, at the same time, the direction indicators
will flash twice. At this point, a second remote control can be paired by pressing any button: the siren will beep
and the direction indicators will flash twice.
Once pairing is complete, the system automatically exits programming mode.
NB: the system exits "radio control programming" mode if it is not used for 10 seconds.
