18
EN
09302
TO EXIT THE GARAGE MODE, SIMPLY SWITCH THE ALARM ON.
9. VEHICLE TRACKING/PANIC ALARM
Press button 4 (TRACKING/PANIC ALARM) to activate the siren and indicators for 25 seconds.
This function is active whether the alarm is armed or disarmed.
10. ANTISABOTAGE ALARM
The system's built-in battery backup enables the alarm to function for 25 seconds even if a general power failure
occurs. The blackout warning time is 25 seconds: if the wires are cut while the alarm is armed, the siren sounds.
When power is restored, the system will return to the state it was in before the power failure.
11. CHECK FUNCTION
Arm the alarm, wait 20 seconds for it to stabilise and then test the correct operation of the 3 main functions within
the remaining 40 seconds of the PRE-ALARMING time.
- SHOCK SENSOR: hit the vehicle to test the motion sensor, the siren will emit a high-pitched beep to confirm
correct operation.
- IGNITION ON: Test the ignition switch (ACC-ON), the siren will emit a high-pitched beep to confirm correct
operation.
- EXTERNAL INPUT (if activated): If the external input is detected, the siren will emit a high-pitched beep to
confirm correct operation.
12. DOUBLE ENGINE STOP
The device is equipped with two separate circuits for blocking the engine which can be used, for example, for
blocking
the starter motor and/or the fuel pump.
1st circuit: green cables and green
2nd circuit: green/white cables and green/white
Once the connections have been made, when the alarm is armed, the vehicle is prevented from starting.
Vice versa, when the alarm is deactivated and the ignition is switched on, the circuits are closed and the vehicle
can be started.
FUNCTIONS THAT CAN BE ACTIVATED
13. ALARM ARMING/DISARMING WITH USER RECOGNITION FUNCTION
Thanks to this function the alarm can be armed and disarmed automatically by means of the radio remote control
signal without pressing any buttons.
To use this function it is necessary to activate it on the main unit (following the procedure shown in the FUNCTIONS
TABLE on page 21) and to activate the user recognition on the radio remote control following the procedure shown in
point 18.
Once activated, if with the engine off, the system does not receive the user recognition signal within 21 seconds, the
alarm is automatically armed: the siren emits 3 beeps, the direction indicators flash and the alarm LED lights up.
The alarm is automatically disarmed, when the system receives the user recognition signal: the siren beeps once, the
direction indicators flash and the alarm LED goes off.
