Phonic POWERPOD 410, User Manual

Page: 5 / 22

1 POWERPOD 410 / POWERPOD 410R
English
INTRODUCTION
Congratulations on your purchase of the Phonic Powerpod
410/Powerpod 410R Powered Mixer. The Powerpod 410/Pow-
erpod 410R is built into a rugged wooden cabinet for heavy-duty
use. In order to get the best performance from your Powerpod
410/Powerpod 410R, please read all of this safety and operation
manual before operating the mixers and keep the manual for
future reference.
FEATURES

4 mono input channels for a wide range of Microphone and
Line level signals from separate input sockets

Built-in 200 Watt power amplifier

Class D circuitry on built-in amplifier

Built-in Digital Delay

Super musical 2-band EQ at mono channels

Record out

Tape in with level control
GETTING STARTED
1. Before turning on the power, set the Master output control to
the off position.
2. Always turn the power off before connecting or disconnecting
cables.
3. Cleck the AC Voltage before connecting the AC plug.
4. Do not obstruct the back panel at all for proper ventilation.
CHANNEL STRIP DESCRIPTION
1. LOW EQ
The control has shelving response giving 15dB of boost or cut
at 80Hz. Add warmth to vocals or extra punch to guitars, drums
and synths by turning to the right. Turn to the left to reduce stage
rumble, hum or to improve a mushy sound.
2. HIGH EQ
Turn to the right to boost high frequencies, adding crispness to
percussion from drum machines, cymbals and synths. Turn to the
left to cut these frequencies, reducing sibilance or hiss. The control
has a shelving response giving 15dB of boost or cut at 12kHz.
3. LEVEL CONTROL
The Level Control determines the proportion of the channel sig-
nal in the mix, and provides a clear visual indication of channel
level.
4. MIC & LINE INPUT
The MIC input accepts XLR phone jack while the LINE input
accepts a 1/4” type phone jack. Please use a low impedance
microphone and a properly wired cable for best results. You can
only use one of the two connectors at the same time.
5. EFFECT
This knob decides the signal level which will be sent to the built-in
digital delay effect control.
MASTER SECTION DESCRIPTION
6. DIGITAL DELAY
The signal from the input channels, processed by the built-in digital
delay will feed to the master output. There are three knobs here
to control the effect of digital delay.
TIME - This knob adjusts the internal time of the delays; turn to the
right to increase the interval time between two delays.
REPEAT - To increase the rate of the delays, turn this knob to the
right. You will hear the signal repeat at a faster rate.
7. POWER INDICATOR
When the power switch at the rear panel is turned on, this indicator
will illumnate so the user may be aware of it.
1 2
3
5
4
6
7