Phonic POWERPOD 410, User Manual

Page: 6 / 22

2 POWERPOD 410 / POWERPOD 410R
English
8. TAPE IN CONTROL
This knob adjusts the level of signal from the Tape In to the Main
bus.
9. MASTER CONTROL
This adjusts the final level of the Main bus. It controls the Main
bus signal which is output to the speakers.
10. TAPE IN AND REC OUT
The TAPE IN sockets allow cassette recorders or CD players to
be added to the Main output. The RECORD OUTPUT, with RCA
phono sockets, provides signal output to a cassette deck and
home audio equipment. The nominal output level and impedance
are -10dBV/600ohms.
REAR PANEL DESCRIPTION
16 POWER SWITCH
This switches the powered mixer on and off. While turn it on, the
power on blue LED indicator will light up on the master section
of front panel.
17. SPEAKER OUTPUT JACKS
Speakers can be connected to these sockets, two speakers can
be connected to the powered mixer. When using 2 speakers at the
same time, use 8~16 ohms speakers. When using one speaker
only, use a 4~8 ohms speaker. The total minimum required load
is 4 ohms. If the total load is less than 4 ohms, it may damage
this powered mixer.
18. MAIN OUT / AMP IN
This unbalanced insert point is a break between the main out and
built-in amplifier to allow the main output to be sent to an external
signal processor or power amplifier. The insert is a 1/4
’ phone jack
socket which is normally bypassed. When a jack is inserted, the
signal path is broken.
The main output signal appears on the TIP of the plug and the
external signal is returned on the RING. A
“ Y ” lead may be
required to connect to equipment with separate send and return
jacks as shown below:
USB RECORDER DESCRIPTION
The USB Recorder’s source signal is taken directly from each
individual input channel. While the recordings are indeed in stereo,
they are also limited by the Powerpod 410R’s circuitry, which is
mono rather than stereo. When playing back a signal, the signal
will pass through the USB In control and then is sent directly to
the main mix. Playback of WAV, WMA and MP3 with bit rates of
up to 320 kbit/s is possible.
11. DISPLAY
This display will display the track number currently being played.
It also offers play, pause and record indicators as well as the
current play/record time.
12. USB PORT
Connect your USB flash drive to this input. Once a drive is
connected, the files will initiate and the main menu will appear
on screen. Users are advised to format their USB memory sticks
with the FAT-32 file system.
16 17 18
13. PLAY BUTTON
Push this button to start and stop playback and recording of the
currently displayed track. Starting a track after it is paused will
resume the track from the point at which it was paused (in both
record and playback mode). When in recording mode, push and
hold this button to finalize recordings.
14. BACK/NEXT BUTTONS
Pushing these buttons will allow users to skip back and forwards
between tracks. When the menu is activated, these buttons are
used to scroll through on screen options.
15. STOP/MENU BUTTON
Push this button to stop playback or recording when applicable.
Push and hold the button to access the USB recorder/player’s
main menu.
8 9
10
12
13 15
11
14