PhoneWatch Smart Alarm, User Manual

Page: 4 / 9

How to use the keypad
The keypad is used to activate or deactivate the alarm system by
means of a PIN code or keytag. The keypad is equipped with
a keytag reader at the bottom.
Signal light 1
Alarm triggered
Signal light 2
System error
Signal light 3
Tamper alarm
Keytag reader
SOS-function SOS-function
Activating
Full Arm mode
Activating
Part Arm mode
Signal lights on the keypad
There are four signal lights on the front of the keypad.
These indicate the current status of the alarm system.
Signal light 1 – alarm triggered
On : The alarm system has been triggered.
Flashing : There is an alarm in the alarm system’s memory which needs to be reset.
Off : The system has no alarms.
Signal light 2 – system error
On : System error. This could be due to a problem with the battery or the
power supply. After too many failed PIN code or keytag attempts, the light will be on
and the keypad will be locked for 5 minutes. If the light persists, contact customer
service for assistance.
Off : The system is free of errors.
Signal light 3 – tamper alarm
On : A tamper alarm has been triggered in the system. This could be due to failure or
tamper. After too many failed PIN code or keytag attempts, the light will be on and
the keypad will be locked for 30 minutes. If the light persists, contact customer service
for assistance.
Off : The system is free of tamper alarms.
Signal light 4 – door/window open
On : Door/window is open when arming/part-arming the alarm.
Off : No door/window is open.
Resetting
You can reset the alarm system by entering your PIN code or using your keytag. If there are
various alarms triggered in the system memory, you will need to repeat this process until
LED lights 1, 2, 3 and 4 are all switched off.
SIGNAL LIGHTS ON THE KEYPAD 7 6 HOW TO USE THE KEYPAD
Signal light 4
Door/window open