PhoneWatch Smart Alarm, User Manual

Page: 6 / 9

PhoneWatch – DOMONIAL USER INSTRUCTIONS 4
Deactivate using the keypad
The entire system will be deactivated, regardless as to whether it was in Full Arm mode or
Part Arm mode .
Enter your PIN code or use the keytag over the keytag reader.
The full arm button light will be switched off to indicate the alarm has been disarmed
from full arm mode.
The part arm button light will be switched off to indicate the alarm has been disarmed
from part arm mode.
When somebody enters a property that is armed or partially armed, the system will generate a
count down sound to indicate that it is necessary to deactivate the alarm system before the count
down finishes, to avoid the alarm triggering.
Deactivate using the remote control
The entire system will be deactivated, regardless as to whether it was in Full Arm mode or
Part Arm mode.
Press and hold the button for 2 seconds to deactivate.
All the button lights will blink to confirm the action and the selected button light
will light up for 2 seconds.
When somebody enters a property that is armed or partially armed, the system will generate a
count down sound to indicate that it is necessary to deactivate the alarm system before the count
down finishes, to avoid the alarm triggering .
Siren and sound
When the alarm is triggered, the siren will sound. The sound will be generated from the optical
smoke detectors, keypad and indoor sirens (if fitted).
You will have two different sounds depending on the type of alarm.
If the sound is constant, there has been a burglar alarm or a panic alarm
If the sound is pulsing, the system has detected smoke
SOS function
The SOS function gives you greater personal security. In an emergency, you can push the SOS
buttons on the keypad or remote control and we will respond in seconds sending the help you
need.
Activate using the keypad
Push and hold the two bottom buttons on the keypad at the same time
for 2 seconds.
The siren will sound immediately and switch off after the alarm has been deactivated.
Activate using the remote control
Push the two upper buttons on the remote control at the same time
for a minimum of 2 seconds.
The siren will sound immediately and switch off after the alarm has been deactivated.
10 HOW TO USE THE ALARM SYSTEM
Portable voice unit
The portable, two-way voice unit (if fitted) allows our Alarm Receiving Centre to contact you if
(and only if) your alarm is activated. In the event of an emergency, you can take it down from
the wall and carry it with you while you get to safety - our Alarm Operator will be with you
every step of the way.
HOW TO USE THE ALARM SYSTEM 11