Phoenix Contact 2986229, User Manual, Page: 80 / 102

PSR-TRISAFE-S
5-6
PHOENIX CONTACT 103503_en_03
Do not confirm this message yet, first complete the following step.
Figure 5-5 Message dialog box following successful data transmission
6. Confirm the new configuration by pressing the "Confirm" button using a pen (see
Figure 5-6).
Figure 5-6 Confirming the configuration with the "Confirm" button
The safety module is then reinitialized (all status indicators are on briefly) and then switches
to safe normal operation (only "PWR" LED on).
WARNING: Risk due to activated outputs.
Following the confirmation described in this step, the safety module starts running
immediately. Provided that no startup inhibit, which must be cancelled manually, is active,
outputs may be activated immediately after startup. Make sure that the safety module
startup will not lead to any hazardous situations.
Startup inhibit active?
If a startup inhibit has been predefined in the configuration, it will now be active following
startup. An active startup inhibit must be cancelled by pressing a reset button which is
connected to the safety module according to the configuration.
For additional information, please refer to "System startup and restart behavior" on
page 2-5.
If the safety module is not initialized correctly, proceed as described in "Problems and
solutions" on page 7-1.
First acknowledge the configuration on
the safety module
(see step 6.) ...
Please note:
... before clicking "OK".
I
0
PW
R
DA
TA
ERR
CO
N
F
I
8
I4
I
1
2
I
1
I9
I
5
I
13
I2
I
10
I6
I
1
4
I
3
I
11
I7
I 15
O
0
I
1
6
O
1
I
1
7
O2
I
1
8
O
3
I
1
A1
A1
A2
A2
24V
0V
O0-
01-
T0
T0
T1
T1
M1
M2
M3
M0
CONFIRM
PSR-TRISAFE-S
CO
N
F
S
TICK